DJI Ace One - Manual (Page 14)

©2012 DJI Innovations. All Rights Reserved. 14 |
B4
Swashplate
You should finish the setup for your swashplate in Manual Mode.
In Ace One Assistant Software, page-SWASHPLATE: STEP1: TX You have to set the transmitter to single
servo swash (Futaba: H-1; JR/Spektrum:1sNORM;
Hitec: 1-Servo 90° ), and Ace One will do the CCPM
instead.
STEP2: Please make your selection according to your
swashplate type. IMPORTANT
STEP3: The swashplate can be rotated in 360°, with 1° step
increase or decrease. Not required in most conditions.
STEP4: Click / button, you can reverse the working
Direction of swashplate servos. Servo Trim is in
range -100 to +100, with default value at 0. The
swashplate must be level. The Current Output will let
you indicates whether your swashplate servos are on
their center position or not.
If you have enabled Flybarless function, then Swash
Mix ratio settings for AILE (Cyclic Roll) and ELEV
(Cyclic Pitch) will not be available, please read
Flybarless setting for detail.
Please read your helicopter ’s manual, and make sure
the swashplate servo linkage and all the mechanical
parts were correctly adjusted before you use the
above function for swashplate level adjusting.
Swash Mix is identical to Tx CCPM mixing, this function is no
longer avaliable on Tx after set to single servo (on Tx).
STEP5: Click / button, you can reverse the moving
direction for PITCH (Collective Pitch), AILE (Cyclic
Roll) and ELEV (Cyclic Pitch).
The Swash Mix ratio is 0~100%, which defines the
maximum working range for PITCH (Collective Pitch),
AILE (Cyclic Roll) and ELEV (Cyclic Pitch), similar to
Tx setting.
Suggestion: 35~45%, it can give you soft flying
movement, and easy to configure for the following
parameters.
B5
Pitch and Throttle Curve Setup
We suggest you to use the following pitch curve for
better lifting power and safety descending speed.
Stick
Pos. -100% 0% +100%
+10˚
-4˚
+5.5˚
0˚
Throttle curve for electric power,
this is the example for JIVE ESC:
-100% 0% +100%
50
0
80
100
Stick
Pos.
Throttle curve for integrated engine (with
governor function):
50
0
100
-100% 0% +100%
Stick
Pos.
STEP2 STEP3
STEP4
STEP5