DJI Ace One - Manual (Page 11)

©2012 DJI Innovations. All Rights Reserved. 11 |
Configuration Procedure
B1
GPS & IMU Mounting
Ace One Assistant Software - MOUNTING page
STEP1: Select IMU Mounting orientation
90º
90º
Backward
Forward
Right
Left
STEP2: Fill in the distance between IMU/GPS and the C.G. of
helicopter in X, Y & Z axles, please measure the C.G.
with following method:
a) Adjust your helicopter, and make it balance on X
and Y axle as shown below.
X
Y Rotor Head
Balance on X Y
b) The C.G. should be on the extended line of
helicopter main shaft.
Main Shaft
Z
c) Hang the helicopter by the tail
and use a plum line to find C.G.
on Z axle. You can use your own
methods to estimate the C.G. of
your helicopter.
*Step c) is not required in pod/boom without
camera mounted, and scale helicopter. Simply
enter value zero will be sufficient.
GPS normally mounted on tail boom, thus X
and Z could be zero, distance between GPS to
main shaft is X.
C.G.
Ground
1
You must re-configure if the ALL-UP-WEIGHT had been changed on your helicopter, e.g. camera mounted or battery
changed.
2
If mounting locations are not accurate enough or the sign were wrong, error on Y
，Z axle will leads helicopter vibrating,
error on X axle will leads drifting during spinning.
STEP1
STEP2