Bowers & Wilkins CWM7 - Manual (Page 8)

8
4.8 A port plug accessory is included with CWM7
Series speakers. The plug can be used if desired to
reduce bass output by obstructing the speaker’s reflex
port. Simply push the plug into the reflex port. The
diagram above illustrates insertion of the port plug. CWM7.4 and CWM7.5 Baffle Insertion
The CWM7.4/5 baffle assembly is held in the back
box by a combination of hinge features and push-lock
fasteners. To secure the baffle assembly in the back
box, lift the baffle up to the back box and engage the
two pegs on its lower edge at an angle within the holes
inside the back box flange. Now simply rotate the baffle
inwards so that the electrical connector engages and
the baffle sits just sub-flush of the back-box flange.
The baffle is held in the back box by two push-
lock fasteners. Push-lock fasteners are secured by
pushing the head inwards – either with a thumb or a
screwdriver. As they secure, the fasteners will click
three times. The baffle will then be secure in the back
box. The diagram above illustrates inserting the baffle
and securing the push-lock fasteners.
Note: Push-lock fasteners are unsecured by turning
anticlockwise with a screwdriver. The supplied
L-shaped tool can now be used to hook and lift
behind the fastener head.