CommScope ATC300-2000 User Manual
Page 8
on the ATC300-1000/2000 browser window.
13. When access to the controller is no longer needed, the IP Config Tool can be closed to restore the
computer to its original IP settings.
* Note: The Reboot button is used to reboot the controller. This is required when firmware
Figure 2-6. Finishing Software Upload.
updates are installed for the controller.
See steps 10 through 12 (Figure 2-6) to complete upload:
10. The software file is uploaded through the Internet browser, which opens the ATC300-1000/2000
operating window on the PC/laptop.
11. Click on Back (Screen 1) to go to the controller’s screen displaying the Reboot button
(Screen 2).
12. Click Close
See www.commscope.com for complete ATC300-1000/2000 User Guide, Bulletin 639544.
Andrew Solutions
Customer Support Center
North America: +1-800-255-1479, Option 1
International: +1-779-435-6500, Option 1
Bulletin 639571 • Revision G • December 2012 Page 8 of 8
ATC300-1000/2000 Teletilt® Control System Computer Interface Setup