Create a backup file for future sessions – CommScope ATC300-2000 User Manual
Page 4
.
2. Use Andrew IP Config Tool to set up a new connection on the local computer.
2. Click on Local Area Connection.
3. Enter a new IP address that is one digit lower
than the controller’s
default setting:
i.e.192.168.255.141.
4. Click Apply new IP configuration button.
5. New IP settings shown, replacing the original IP
Figure 2-1. Using The IP Config Tool To Connect The Controller To The Network.
settings on the local PC/laptop.
•Double-click on the IP Config Tool icon that was
placed on the computer’s desktop during
installation.
• To temporarily change the IP settings on the
local PC/laptop, follow these steps (Figure 2-1):
1. Click on New IP Info tab.
3. Create a backup file for future
sessions.
1. Click on Backup/Restore tab (Figure 2-2).
2. Click on the Backup button.
3. Type in a name for the new IP backup file.
(Example: Cellsite name where controller
resides)
4. Click on OK
Figure 2-2. Creating A Backup File.
Bulletin 639571 • Revision G • December 2012 Page 4 of 8
ATC300-1000/2000 Teletilt® Control System Computer Interface Setup