beautypg.com

0 configuring the controller’s static ip address – CommScope ATC300-2000 User Manual

Page 6

background image

3.0 Configuring the Controller’s Static IP Address

See Section 7.1.1 in the Operations Manual, Bulletin 639544, for instructions to configure the static IP on

the ATC300-1000/2000 Controller.

4.0 Using Andrew IP Config Tool to Upload Software Updates

to the Controller

Upload the software file update to the controller:

ATC300_*.tar Controller software file with bundled antenna definition file and

Andrew actuator firmware

• Asterisk (*) in filename represents the version number. Use the file with the highest number

preceding the file extension for each type file to ensure the latest version data is uploaded.

The controller will not recognize updates made to the ‘ATC300_*.tar’ file until it has been

rebooted.

Note: See Bulletin 639544, Section 10, for uploading software files to the actuator.

Follow steps 1 through 9 (Figure 2-5 on the next page) to upload software updates to the

controller.

1. Click on FTP Server tab on the IP Config main screen. See Screen 1.

2. Click Find Files to open the Find Files dialog box shown in Screen 2.

3. Click Find Files to search for controller files. See Screen 2.

4. Select files. (Use the latest version.)

5. Click Add Selected Files.

6. Click on Finish to return to Screen 1, and view files available for upload.

7. To upload files (Screen 1), select the file.

8. Click on Upload.

9. Enter IP address for active controller in the Controller IP dialog, choose ATC300 model and

click OK.

ATC300-1000/2000 Teletilt® Control System Computer Interface Setup

Bulletin 639571 • Revision G • December 2012 Page 6 of 8

This manual is related to the following products: