Use andrew ip config tool to access the controller – CommScope ATC300-2000 User Manual
Page 5
browser should be minimized while using the IP Config Tool to upload software updates.
4. Use Andrew IP Config Tool to access the controller.
file.
3. Click on Restore.
Figure 2-3. Using The IP Config Tool To Access The
Controller.
4. Backup IP settings are restored to a local
computer.
• Verify that the controller is powered up
and connected to the computer’s
Ethernet port using the Ethernet
crossover cable provided. To start a
new session, double click on the IP
Config Tool icon on the computer’s
desk-top.
• To restore temporary IP settings on the
PC/laptop that were saved in the IP
Config Tool, follow these steps (Figure 2-3):
1. Click on Backup/Restore tab.
2. Select the Backup
• Open an Internet browser (Netscape and Mozilla are not supported). See Figure 2-4.
If the ATC300-1000/2000 controller interface does not automatically appear in the Internet browser,
type in the controller’s IP address into the URL address window, and click on Go. The factory
default IP address for the ATC300-1000/2000 controller is: 192.168.255.141.
• After verifying that the controller’s interface can be viewed in the Internet browser, the Internet
Figure 2-4. ATC300-1000/2000 Controller Main Interface Screen.
ATC300-1000/2000 Teletilt® Control System Computer Interface Setup
Bulletin 639571 • Revision G • December 2012 Page 5 of 8