Statement of purpose, Notices and precautions, Warranty notice – CommScope ATC300-2000 User Manual
Page 2: Safety notice
Notices and Precautions
and Operation User Guide.
Products→Antennas→Teletilt® RET System
Statement of Purpose:
This guide describes how to use a CommScope PC software tool, IPConfigTool, to establish
communication with an ATC300 and update its software to the latest release.
liability or responsibility for the results of improper or
unsafe installation practices.
It is recommended that transmit power be turned off
when the field installation is performed. Follow all
Installation Training Available at Andrew Institute
applicable safety precautions as shown on thispage.
procedures discussed in this bulletin may cause warranty for such products to be void.
Andrew requires pretesting actuators on the ground prior to installation using the Andrew
portable controller and the latest version of the controller software (available online at
www.commscope.com/andrew under
defined by Andrew will void warranty.
release is installed on the actuator. Failure to conduct pre-test and pre-installation procedures
Failure to assure installations are done properly by trained installation personnel and to follow
proper actuator functionality and also ensure that the latest available actuator firmware
). This will verify
WARRANTY NOTICE
Proper installation procedures must be followed when installing and operating RET equipment.
SAFETY NOTICE
The installation, maintenance, or removal of an
antenna requires qualified, experienced personnel.
Andrew installation instructions are written for such
installation personnel. Antenna systems should be
inspected once a year by qualified personnel to
verify proper installation, maintenance, and
condition of equipment. Andrew disclaims any
More information on these topics may be found in Bulletin 639544 ATC200-1000 &
ATC300-1000/2000 Teletilt Remote Control Variable Electrical Downtilt System Installation
Please contact the Andrew Customer Support Center, (see bottom of cover page),
for any questions.
Do not install near power
ATC300-1000/2000 Teletilt® Control System Computer Interface Setup
Bulletin 639571 • Revision G • December 2012 Page 2 of 8
lines. Power lines, telephone
lines, and guy wires look the
same. Assume any wire or
line can electrocute you.
use metal ladder.
is in the area. Do not
lightning or thunder
or windy day or when
Do not install on a wet
Wear shoes with rubber
soles and heels. Wear
protective clothing
including a long-sleeved
shirt and rubber gloves.