Clay Paky GLOW UP STRIP 100 & FLIGHT CASE (F21250) - Manual (Page 13)

GLOW UP STRIP 100
LED CONTROL
It allows you to select the operating mode of the GLOW UP Strip 100
between the two available:
1) Press ENTER
A – the current setting appears on the display.
2) Use the UP B and DOWN C keys to select one of the following settings:
Common Mode: all LEDS are on simultaneously (page 22)
Single Mode: The LEDS are divided into 2 sets of 5 LEDS each (page 23).
Press ENTER
A to confirm the selection (the display blinks for several
seconds) or SELECT S to keep the current settings and return to the
previous Menu.
LED CURRENT
This allows you to set an operating current value for the Glow UP Strip 100
LED, whether it is running in Battery or PowerCon mode.
1) Press ENTER
A – BATTERY MODE / POWERCON MODE appears
on the screen.
2) Use the UP B and DOWN C buttons to select one of the 2 options.
3) Press ENTER A .
4) Use the UP B and DOWN C to select 700mA or 1000mA, it is possible
to associate different values depending on the selected operating mode,
(Battery Mode default: 700ma / PowerCon Mode default: 1000mA).
5) Press ENTER A to confirm or press SELECT S to return to the
previous Menu.
BATTERY POWER
It allows you to assign a maximum battery charge power (default 50%).
The higher the assigned percentage, the lower the battery charge duration
and vice versa.
1) Press ENTER
A – the current setting appears on the display.
2) Use the UP B and DOWN C keys to increase or decrease the
percentage to be attributed (minimum value 40%).
Press ENTER E to confirm the selection (the display blinks for several
seconds) or SELECT
S to keep the current settings and return to the
previous Menu.
POWER MODE
Lets you select the set G.U.S. 100 power type.
1) Press ENTER – current settings appear on the display.
2) Use the UP and DOWN keys to select one of the 3 following options:
AC Mode: only runs with mains power, in the event of power outage, the
G.U.S. 100 turns off.
BATTERY Mode: directly battery powered when turned on without
mains power; if mains power is on or connected later, it automatically
charges to 100% maximum charge and then stops charging; if mains
power is turned off, it turns off (as with flight case).
MIXED Mode (default): mixed operations, as per first firmware release.
3) Press ENTER to confirm the selection (the display blinks for several
seconds) or SELECT to keep the current settings and return to the
previous Menu.
DISPLAY
Allows you to dim the display backlight 60 seconds after switching to idle
status. To turn it back on, simply press any key.
1) Press ENTER
A – current settings appear on the display.
2) Use the UP B and DOWN C keys to turn display backlight OFF or ON.
3) Press ENTER A to confirm the selection (the display blinks for
several seconds) or SELECT S to keep the current settings and
return to the previous Menu.
CONTRAST
Lets the user modify display contrast.
1) Press ENTER
A – current settings appear on the display.
2) Use the UP B and DOWN C keys to modify the value from 0 to 10
according to the desired contrast.
3) Press SELECT S to return to the previous Menu.
13 Continued ➔
Contrast
Display
Battery
Power
Power
Mode
Advanced Setup
Led
Control
Led
Current
Battery
Mode
PowerCon
Mode