Clay Paky GLOW UP STRIP 100 & FLIGHT CASE (F21250) User Manual
Page 12
12
GLOW UP STRIP 100
DMX MODE
Assigns the desired command to the GLOW UP Radio module
1) Press ENTER
A
– current settings appear on the display.
2) Use the UP
B
and DOWN
C
keys to select one of the following
settings:
•
SLAVE PRIORITY: GLOW UP runs as a Slave
Press ENTER
A
and use the UP
B
and DOWN
C
keys to select
the DMX signal reception priority in case of conflict between the cable
and wireless signals
•
Cable (default)
• Wireless
Press ENTER
A
to confirm the selection (the display blinks for
several seconds) or SELECT
S
to keep the current settings and
return to the previous Menu.
•
MASTER OUTPUT: GLOW UP runs as a Master
Press ENTER
A
and use the UP
B
and DOWN
C
keys to select
how the DMX signal should be sent to other devices:
Cable+Wireless
Cable
Wireless
Press ENTER
A
to confirm the selection (the display blinks for
several seconds) or SELECT
S
to keep the current settings and
return to the previous Menu.
•
REPEATER: GLOW UP runs as a repeater
Press ENTER
A
and use the UP
B
and DOWN
C
keys to select
how to run GLOW UP as a repeater: :
Direction – Press ENTER
A
again and use the UP
B
and DOWN
C
keys to select whether the repeater should transmit the DMX signal from:
-Wireless to Cable
-Cable to Wireless
Press ENTER
A
to confirm the selection (the display blinks for
several seconds) or SELECT
S
to keep the current settings and
return to the previous Menu.
Function– Press ENTER
A
again and use the UP
B
and DOWN
C
keys to select whether the repeater should run from:
- Repeat & Play (GLOW UP repeats and plays)
- Repeat Only (GLOW UP operates in repeat mode only)
Press ENTER
A
to confirm the selection (the display blinks for
several seconds) or SELECT
S
to keep the current settings and
return to the previous Menu.
Enable/Disable
Press ENTER
A
to confirm the selection (the display blinks for
several seconds) or SELECT
S
to keep the current settings and
return to the previous Menu.
LOCK OPTION
It lets you assign a lock password, requested at each projector start up.
The same password can be used to access the "Menu Advanced".
1) Press ENTER
A
and access the Lock menu to enable ON or disable
OFF the password request at start up.
- Select ON to enable. The previously entered password is displayed
and the desired numerical password can be entered with the UP
B
e DOWN
C
and ENTER
A
keys.
- By selecting OFF, no password will be requested at projector start up.
2) Access the Set Password menu and use the UP
B
, DOWN
C
and
ENTER
A
keys to assign the desired Password number.
AUTO SWITCH-OFF OPTION
Lets you enable G.U.S. 100 shutdown in the event of disuse for more than
4h, when battery powered.
1) Premere ENTER
A
sul display appare l'impostazione corrente.
2) Con i tasti UP
B
e DOWN
C
, abilitare ON o disabilitare OFF l'opzione.
3) Press ENTER
A
to confirm the selection (the display blinks for several
seconds) or SELECT
S
to keep the current settings and return to the
previous Menu.
Lock
Option
Auto Switch
Off
DMX
Mode
Advanced
Setup