Calculated Industries 6130 v3.0 - Manual (Page 6)

When in programming mode, this
key moves the cursor back to the
previous item programmed.
[Scale] – Scale key
Used to cycle through the various
scales within each scale mode.
When in the programming mode,
this key moves the cursor forward
to the next item to be programmed.
[M+] – Memory key
Used to add and store a displayed
value into Memory. When pressed,
the value is added to memory, the
display is cleared to “
0, ” and the in-
dicator “ M” lights. When in pro-
gramming mode, this key advances
the flashing digit or units by one.
[Length] – Length key
Used to store a value in the Length
register or recall the current value
stored in the Length register.
[Width] – Width key
Used to store a value in the Width
register, or recall the current value
stored in the Width register.
6 – Scale Master ® II v3.0