Calculated Industries 6130 v3.0 - Manual (Page 25)

Setting a Constant Value (+K)
This key is used to add a pre-pro-
grammed value to the displayed mea-
sured value.
If the value is not “live,” then pressing
this key will first reset the display, then
add the constant value. When a con-
stant value is added, the value in the
display remains a “live” value.
To set a constant:
1) Press [Set] [+K]. The appropriate
annunciator will begin flashing “ FT
-
IN ” for Imperial Mode, “ MM ” for
Metric Mode. The constant annun-
ciator (a small
k ) will appear in the
scale box display.
2) To change the units of measure-
ment, press [M+] . You can repeat-
edly press this key until you reach
the desired unit of measurement.
Press
[Scale] to begin setting the
distance. The first zero will start
flashing.
User’s Guide – 25