Calculated Industries 6130 v3.0 - Manual (Page 5)

[Sub] is pressed simultaneously with
[Count]
, [+K] or [M+], the unit will
subtract the appropriate value.
[Count] – Count key
Used to increase the Count value by
one. Count is active in all modes.
Pressing [Reset] and [Count] simulta-
neously will clear the count.
[+K] – Constant key
Used to add a pre-set “constant”
value to the displayed measured
value. To set a constant value, you
press [Set] [+K] to place the unit in
programming mode.
[Rcl] – Recall key
Used to recall stored values. When
you press [Rcl] [Rcl], the last value
rolled is displayed.
[Mode] – Mode key
Used to cycle through the following
scale modes (in sequence):
1) Architectural ( ARCH );
2) Engineering 1 ( ENG 1 );
3) Engineering 2 ( ENG 2 );
4) Map ( MAP );
5) Custom ( CUSTOM ).
User’s Guide – 5