Calculated Industries 6130 v3.0 - Manual (Page 21)

Setting a Custom Scale
1) Press [Mode] until 1:CUS_x (x being
a number 1-4) appears in the scale
box display.
2) Press [Set] [Scale] . “ ROLL ” will ap-
pear in the main display.
3) Press [Scale] again to begin enter-
ing the custom scale. The appro-
priate annunciator will begin
flashing “
FT
-
IN
” for Imperial Mode,
“ MM
” for Metric Mode.
4) If you want to change the units of
measurement, press [M+] . You can
repeatedly press this key until you
reach the desired unit of measure-
ment. Then press the
[Scale] key to
begin setting the distance.
5) In Imperial mode, the scale will be
one inch to whatever you set. In
Metric mode, it will be one mil-
limeter to whatever you set. Press
[M+] to increment the distance.
When you have reached the correct
number, press
[Scale] to advance to
User’s Guide – 21