Calculated Industries 6130 v3.0 - Manual (Page 10)

“Rolling” a Measurement
To take a measurement with the Scale
Master II
:
1) Switch the unit on. If the display
does not show zero (0), press the
[Reset] key to clear the display.
2) Select your type of scale by press-
ing the [Mode] key. Then press the
[Scale] key to select your scale.
3) Begin rolling. The display will reg-
ister your measurements. When
you roll the unit, be sure to hold the
unit upright (see picture 1 - next
page).
Also make sure you start and stop
at the exact points you are measur-
ing. Otherwise your roll may not
be accurate (see picture 2).
4) To store your measurement, press
the appropriate key (ex. [Length] to
label as length, [Width] to label as
width, etc).
5) Press [Reset] to reset the unit and
begin a new measurement.
10 – Scale Master ® II v3.0