Calculated Industries 3088 - Manual (Page 20)

Memory Calculations
1. 10 [Feet] 5 [Inch] [M+]
5 [Feet] 3 [Inch] 1 [/] 16 [M+]
Recall Memory [Rcl] [M+] 15 FT 8-1/16 IN
Clear Memory [Rcl] [Rcl]
NOTE: After using Memory in a calculation, be sure
to clear the Memory [Rcl] [Rcl] to avoid carrying-over
values from the previous calculation.
2. 105 [Inch] [M+]
45 [Inch] [M+]
37 [Inch] [Conv] [–] [M+]
Recall Memory [Rcl] [M+] 113 IN
Clear Memory [Rcl] [Rcl]
FRACTION SETTING
When you turn on your calculator, it is set to
display values to the nearest 64th of an inch, but
by using the [Conv] key in conjunction with the
number 2, 4, 8, 1, 3, you can change that to show
no lower than 1/2, 1/4, 1/8, 1/16 or 1/32.* The
fraction will remain set until an All-Clear [Conv]
[x] is performed or until you change the Fraction
Set further. You can set the fraction either after
a value is displayed or prior to performing any
calculations.
NOTE: For all the examples in this manual, the
fraction will be set to the default of 64ths.
* No matter what fraction value you use, the calculator will
always show you the lowest common denominator of your
fraction — i.e., 1/2 not 16/32.
20 — Construction Master III ®