Calculated Industries 4094 User Guide - Manual (Page 33)

U
ser
’
s
G
Uide
— 31
– Square Inches (area answers
always displayed in Square Inches
— e.g., Feet x Feet = Square Inches)
– Square meters (area answers
always displayed in Square Meters
— e.g., Feet x Feet = Square Meters)
3) Volume Display Format – * Standard (if units entered are
the same — e.g., Feet x Feet x
Feet — the answer will remain
in this format (cu. ft), but if units
entered are different — e.g., Feet
x Feet x Inches — vol. answer will
always be displayed in Cubic Feet)
– cubic feet (vol. answers always
displayed in Cubic Feet, regardless
of unit entry — e.g., Inches x
Inches x Inches = Cubic Feet)
– cubic meters (vol. answers
always displayed in Cubic Meters,
regardless of unit entry — e.g.,
Feet x Feet x Feet = Cubic Meters)
4) Meter Linear Display – * 0.000 (linear Meter answers
are always displayed to third
decimal place)
– floAt (linear Meter answers are
displayed to the maximum number
of decimal places — e.g., 1.2345
M + 2.56 M = 3.7945 M)
5) Decimal Degree Display – * 0.00°
– floAt
6) Fractional Mode – * Standard (fractions are
displayed to the nearest fraction)
– constant (fractions are displayed
in the set fractional resolution)