Calculated Industries 4094 User Guide - Manual (Page 32)

30 — P
lUmbinG
C
alC
™ P
ro
Meter Linear Display 0.000
Decimal Degree Display 0.00°
Standard or Constant Fractional Resolution Standard
Mathematical Operations Order of Operations Method
*Depressing the Reset button located above the [Angle/Slope] key will also
perform a Full Reset.
aPPEndix c –
Preference Settings
The PlumbingCalc Pro has Preference Settings that allow you to
customize or set desired dimensional formats and calculations.
If you replace your batteries or perform a Full Reset* (press  ,
hold down  , and press  , your calculator will return to the
following settings (in addition to those listed on the previous page):
*Depressing the Reset button located above the  will also
perform a Full Reset. Asterisks below indicate default values.
Preference options
1) Fractional Resolution – * 1/16 (displays fractional values
to the nearest 16th of an Inch)
– 1/32
– 1/64
– 1/2
– 1/4
– 1/8
2) Area Display Format – * Standard (if units entered are
the same—e.g., Feet x Feet—the
answer will remain in this format
(Square Feet), but if units entered
are different — e.g., Inches
x Feet—area answer will be
displayed in Square Feet)
– Square feet (area answers
always displayed in Square Feet,
regardless of unit entry — e.g.,
Inches x Inches = Square Feet)