Using the pipe trades pro pipe material key – Calculated Industries 4095-C User Guide User Manual
Page 26

U
ser
’
s
G
Uide
— 27
USinG THE PiPE TRadES PRo
Pipe Material Key
The Pipe Material key lets you choose a pipe material, which
defines the available sizes and surface roughness used by the
calculator. See Appendix A on page 53 for more information.
The default material for the Pipe Trades Pro is Steel, but the
user can choose from material types as shown.
KEYSTROKE
DISPLAY
0.
(Steel)
MATL StEEL
(Stainless Steel)
MATL S.StEEL
(Brass)
MATL brASS
(Aluminum)
MATL AL.
(Cast Iron)
MATL CASt
(Plastic)
MATL PLAStIC
(Copper)
MATL COPPEr
The last material setting displayed is selected, and the
calculator will retain your setting even after the power has been
turned off. Once a material is selected, you can easily toggle
through the available types (Schedules, etc.) using the Pipe
Type function ( ). Available types of pipe are dependent
upon the material setting.
Keystrokes below show the pipe types available for Plastic
(press until “PLAStIC” is shown in the display).
KEYSTROKE
DISPLAY
0.
MATL PLAStIC
(Schedule 40)
TYPE 40 PLAStIC
(cont'd)