Bully Dog 54100 Rapid Flow Induction Cold Air Intake - Manual (Page 4)

3
Parts Description:
This section describes each part and any special features of each part that need to be noted
to assist with installation. All parts will be referred to during installation by the names used
in this section.
The RFI base: The base to the enclosure that holds the filter has a couple of features to
note. The first is the circular hole on the back of the base, this hole is where the RFI tube
will snap into the base and hold secure the air filter. The second important part of the base
are the two circular holes, the rubber grommets from the stock intake will be placed there
during installation.
The RFI lid: The lid is very easy to remove for filter maintenance, be aware that the tongue
and grove formed between the housing base and the lid needs to be properly lined up for a
good seal. The latch mounts on the lid should always match up with the latch mounts on the
base.
Parts Description