Rfi prep – Bully Dog 54100 Rapid Flow Induction Cold Air Intake User Manual

Page 14

Text mode
Original mode

3. Carefully remove the foam from the stock
intake. The foam has some glue holding it
in place so the foam may rip if it is pulled off
too quickly.

4. Replace the foam onto the RFI. This foam
will create a seal against the fender well to
help ensure that no hot air travels from the
engine bay to the fender well.

5. Remove the MAF sensor from the stock intake using a phillips head screw driver. Place the
MAF sensor into the RFI tube and secure it using phillips head screw driver and the stainless
black oxide screws. See the installed picture on the following page.

RFI Prep