Bully Dog 53253 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 19)

18
5. Install the Bully Dog CCV tube over the stock CCV breather tube and secure the connection
by tightening the #8 clamp. Connect the other end of the Bully Dog CCV tube to the Stage 2
Tube’s recirculation connection point and tighten the clamp to secure the connection.
6. Place the air filter over the MAF sensor tube on the inside
of the RFI intake bottom. Position the air filter onto the end
of the tube so that the filter points slightly downward and
then tighten the air filter clamp with a flat head screw driver.
The clamp should be tight enough that it is very difficult to
pull the air filter off of the tube with your bare hands.
RFI Installation