Bully Dog 53253 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 13)

12
3D. Finally remove the entire stock intake tube as one single piece.
4. Completely remove the stock CCV tube.
Pay special attention to the clip mechanism
on the end of the stock CCV tube that keeps
it connected to the CCV breather, this part
could be easily broken if it is not
properly removed.
Install Tip: Rotate the
stock CCV Tube around until you
can see the clip as depicted in the
photo above. Use a screw driver
to gently lift the clip over the barb
on the CCV breather tube and the
stock CCV tube will slide right off of
the breather tube.
Stock Removal