Bully Dog 53253 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 10)

9
2. First remove the engine cover.
Pull up on the front most part of
the engine cover to release it from
the two pegs that hold its grom-
mets. Once you feel it release
simply pull it strait out towards
the front of the engine.
Install Tip: Notice that the rubber
grommets that hold the engine
cover to the pegs underneath will
sometimes stay on the pegs like
what is seen in the picture to the
left. If this happens, remove the
grommets and place them back
into the proper spots on the bot-
tom side of the engine cover.
Removing the stock intake continued:
1
. IMPORTANT: Before beginning
Installation, disconnect negative
battery clamps.
Failure to do so could result in
injury or damage to your vehicle.
Stock Removal