Bully Dog 4161x 4-Bank 6-Position Chip - Manual (Page 8)

7
inSTAllATiOn STePS
Install the 6 posItIon sWItch early ’94-‘97
In these steps you will install the switch inside the cab
‘94-’97 vehicles.
IMPORTANT: The steps on this page are for ’94-’97 model ve-
hicles. If your vehicle is not a ’94-’97 skip the steps on this page.
1. When you put the ECU back in place you will need to snake the cable through the housing that holds
the ECU in place.
2. Find a suitable place to install the switch. If you
are going to drill a hole in the dash you will need a
13/32” drill bit.
3. If you need to disassemble the switch in order to get it through the hole that you have chosen for your location, the but-
ton can be removed with a 5/16” Allen Wrench.
4. Also remove the 13mm nut. Then when you put the
switch through the hole, replace the 13mm nut to keep
the whole switch from turning.
6 Position Switch
Switch Location on ‘94-’97
6 Position Switch Knob Removed
13 mm Nut
Moun
ting Loc
ation