Bully Dog 4161x 4-Bank 6-Position Chip - Manual (Page 3)

2
inTrOduCTiOn
INTrOduCTION
Welcome to the world of increased power, performance and economy brought to you by the leader in perfor-
mance, Bully Dog Technologies. This set of instructions outlines how to install and operate the 6 Position Chip
for the 7.3L Ford Power Stroke. The 6 Position Chips have been specially designed by the engineers at Bully Dog
to add additional horsepower and economy to the 7.3L Power Stroke.
Note: This instruction set and the included 6 Position chip are made for the ’94-’03 7.3L Ford Power Stroke. This chip
will not work on any other vehicle other than the stated make, model and year. Officially there were no ’98 model Power
Stroke vehicles produced by Ford, these vehicles are referred to as early ’99 vehicles.
IMPORTANT: Performance Chips must always be removed before taking the vehicle in for any kind of service, as it
may interfere with diagnostic tools.
bIll of materIals
1. 6 Position Chip
2. 6 Position Switch
tools needed
5.5mm Wrench or Socket
7mm Wrench or Socket
10mm Wrench or Socket
13mm Wrench or Socket
5/16” Allen Wrench
Sharp Knife or Razor Blade
Drill & 13/32” Drill Bit
Scotch Bright Pad
1.
IMPORTANT: DISCONNECT THE BATTERY BEFORE YOU BEGIN INSTALLATION