Bully Dog 4161x 4-Bank 6-Position Chip - Manual (Page 14)

13
FrEquENTLy ASkEd quESTIONS
CONDITION POSSIBLE SOURCES ACTION
Truck Won’t Start Installation/Connection
Check the connection between the 6 Position Chip and the
computer.You have to remove the silicon completely off of
the computer board before plugging in the 6 Position Chip.
Make sure that you have the correct part # for your truck
year and transmission.
Is it important that the
battery be disconnected?
Installation
Yes, it is very important that you follow the steps as outli-
ned. Failure to do so could result in damage to your ECU.
Truck Stalls
Installation/Connection
Check your connections. Again all silicon on the computer
has to be cleaned off to ensure a proper connection
between the 6 Position Chip and the computer.
Switch
If the truck stalls when switching from one position to the
next, try starting the truck in the position where the truck
stalls. Either the switch could be bad or the 6 Position Chip
could be missing a program.
No Power Increase Installation/Connection
Check the connection between the computer and the 6
Position switch.
Black Smoke Programming
To reduce black smoke, set the 6 position chip to a lower
horsepower level.
For more information on an up-to-date troubleshooting guide, please visit:
www.bullydog.com/Product_Updates.php
TrOuBleShOOTing