Bully Dog 4161x 4-Bank 6-Position Chip - Manual (Page 12)

11
Note: There are many places on the Early ’99-’03 vehicles where the 6 Position switch can be located. If you
are looking for easy access the best place to install the switch is next to the steering column nearest the
driver’s side door. If you want the switch hidden, on most models there is a hole directly underneath the
steering column that is perfect for installing the switch.
IMPORTANT: The steps on this page are performed on Early
‘99-’03 vehicles only. If your vehicle is not an Early ‘99-’03 skip
this page.
Install the 6 posItIon sWItch early ’99-’03
vehIcles
In these steps you will install the switch inside the cab ’99-
’03 vehicles.
1. When you put the ECU back in place you will need to
snake the cable through the housing that holds the ECU in place.
2. Find a suitable place to install the switch If you are going to drill a hole in the dash you will need a
13/32” drill bit.
3. If you need to disassemble the switch in order to get it
through the hole that you have chosen for your location, the
button can be removed with a 5/16” Allen Wrench.
4. Also remove the 13mm nut. Then when you put the
switch through the hole, replace the 13mm nut to keep
the whole switch from turning.
6 Position Switch
Switch Location on ‘99-’03
6 Position Switch Knob Removed
13 mm Nut
Moun
ting Loc
ation
Mounting L
ocation
inSTAllATiOn STePS