brite-View LinkE Air BVH-5101C User Manual User Manual

Page 25

TKIP/AES Network/Address/Port/Key/Session

timeout

WEP Encryption Setting

Wired Equivalent Privacy (WEP) is implemented in this device to prevent

unauthorized access to your wireless network. The WEP setting must be as same as

each client in your wireless network.
z Authentication

Type:

Open, Shared and Auto. When choose “Open” or “Shared”,

all of the clients must select the same authentication to associate this AP. If

select “WEP Auto”, the clients don’t have to use the same “Open” or “Shared”

authentication. They can choose any one to authenticate.

z Default Key ID: Select the Key ID as the default Key.
z Key 1/2/3/4: Select “ASCII” or “Hex” and then type the key in the text field. It will

check whether the number of characters meet 10 or 26. If not, an error message

is shown.
64-bit WEP Encryption：64-bit WEP keys are as same as the encryption

method of 40-bit WEP. When input 10 hexadecimal digits (0-9, a-f or A-F) or

5 ACSII chars as the key, it is using 64-bit WEP encryption.

128-bit WEP Encryption：128-bit WEP keys are as same as the encryption

method of 104-bit WEP. When input 26 hexadecimal digits (0-9, a-f or A-F)

or 10 ACSII chars, it is using 128-bit WEP encryption.

WPA Authentication Mode

This device supports six WPA modes including WPA-PSK (Pre-Shared Key), WPA,

WPA2-PSK, WPA2 and additional WPA/WPA2 PSK and WPA/WPA2 mixed mode.

For individual and residential user, it is recommended to select WPA-PSK or

WPA2-PSK to encrypt the link without additional RADIUS server. This mode requires

only an access point and client station that supports WPA-PSK. For WPA/WPA2,

authentication is achieved via WPA RADIUS Server.

z WPA/WPA2-PSK:

Pass

Phrase:

Option: Pass Phrase (8-32bytes). This mode requires only an access point

and client station that supports WPA-PSK. The WPA-PSK settings include Key

Format, Length and Value. They must be as same as each wireless client in

your wireless network. When Key format is Passphrase, the key value should

have 8-63 ACSII chars.
Key Renewal Interval:

The WPA Algorithm will regroup the key for a period. The default value is 3600

seconds and you can adjust the time interval.