Blizzard Lighting KLIMATEKONTROL DMX Controller User Manual

Page 9

KLIMATEKONTROL Manual Rev A.

Page 9

3.1.4 Resetting The System

WARNING: This will reset the controller to its factory defaults. ALL PRO-

GRAMS AND SETTINGS WILL BE ERASED!

1. Turn the unit off.

2. Press and hold &

3. Turn the unit on while you continue to hold &

4. All LEDs will blink. Release the held buttons and the LEDs will stop

blinking.

5. The settings will be reset to factory defaults.

3.2 Programming

Regardless of whether you are programming a chase or scene, you must fi rst

enter programming mode.

3.2.1 Entering Programming Mode

1. Press and hold for 3 seconds.

2. The Program/REC LED indicator will blink, indicating programming is

active.

3. The LED indicators for any previously programmed scenes in the cur-

rent bank and any previously programmed chases will blink.

4. Programming mode is now active.

3.3 Color/Scene Preset Programming Mode

This allows the user to create a preset color/scene which can be used to

override current fi xture output and may also be used in chase programming.

3.3.1 Creating A New Color/Scene Preset

1. Enter programming mode as described in Section 3.2.1.

2. Using

the

button(s), select the fi xtures to

include in the Color/Scene Preset.

3. Adjust

the

fi xture(s) output using as

desired.

4. Press

5. Select the desired scene bank using .

6. Press

. All LEDs will fl ash quickly.

7. Repeat steps 1-6 to add additional presets if desired.

8. Hold

for 3 seconds to exit programming mode.

The LED indicator above the button will extin-
guish.

3.3.2 Color/Scene Preset Delete Mode

This allows the user to delete a previously programmed preset color/scene.

1. Enter programming mode as described in Section 3.2.1.

2. Select the desired scene bank using .

3. Hold

, then press the button you wish