Operating instructions, 3 the led display screen, Cp1.1-cp4.8 – Blizzard Lighting KLIMATEKONTROL DMX Controller User Manual
Page 8: Cas1-cas8, St01-st32, Null
KLIMATEKONTROL Manual Rev A.
Page 8
Copyright © 2012 Blizzard Lighting, LLC.
ALL RIGHTS RESERVED
3. OPERATING INSTRUCTIONS
3.1 Setup
3.1.1
Setting Up The System
Plug the AC to DC power supply to the system back panel and to the mains
outlet.
Plug in your DMX cable(s) to your intelligent lighting as described in the
fi xtures respective manual. For a quick lesson on DMX see the DMX Prim-
er section in the Appendix of this manual.
3.1.2 Fixture Addressing
The Controller is programmed to control 4 channels of DMX per fi xture,
therefore the fi xtures you wish to control with the corresp
onding FIXTURE
buttons on the unit, must be spaced 4 channels apart.
Fixture
Number
DMX Start Address
Binary DIP Switch
Settings
(SET TO ON POSI-
TION)
1
1
1
2
5
1, 3
3
9
1, 4
4
13
1, 3, 4
5
17
1, 5
6
21
1, 3, 5
7
25
1, 4, 5
8
29
1, 3, 4, 5
Please refer to your individual fi xture’s manual for detailed DMX addressing
instructions. The table above refers to a standard 9-DIP Switch binary con-
fi gurable device.
3.1.3 The LED Display Screen
KLIMATEKONTROL features a 4-position LED display which provides informa-
tion about the current mode, function and status of the controller. The mes-
sages displayed on the screen are detailed here:
LED Display
Means...
CP1.1-CP4.8
Color/Scene Preset, Bank 1-4, Preset 1-8 is selected. Bank is the fi rst digit,
preset is the second.
CAS1-CAS8
Chase 1-8 is selected. The display will change to the current chase step after a
moment.
St01-St32
Chase Step 1-32 is currently running. The display will step through chase steps
based on the current output mode (Auto/Music/Manual)
D000-D255
DMX value currently being assigned by the active fi xture control fader.
F01-0 - F20.0
While holding down the
1-20 fl ashes per second
0.1-60.00
Chase scene time. From 0.1-60 seconds per step.
P000-P100
Chase fade time. From 0-100% of the current chase scene time.
M001-M100
Sound sensitivity, used in music control mode.
L001-L200
Loop Time. The time a chase will loop before moving to the next selected chase.
NULL
Displayed when the user selects a chase/scene which has not been recorded.