Bird Technologies 8578B150 Series - Manual (Page 15)

Introduction
3
Unpacking and Inspection
1. Carefully inspect the shipping container for signs of damage.
2. Do one of the following:
•
If damage is noticed, do not unpack the unit. Immediately notify the
shipping carrier and Bird Electronic Corporation of the damage.
•
If the container is not damaged, unpack the unit. Save the packing
materials for repacking.
3. Inspect all of the components for visual signs of damage.
Note:
Immediately notify the shipping carrier and Bird Electronic
of equipment damage or missing parts.
Site and Shelter Requirements
The equipment is not intended for outdoor use, or use in areas of condensing
humidity. The surrounding air must be free of contaminants or particles that
could be drawn into the air intakes. These load resistors have no intermediate
dielectric fluids or coolant and require no cooling water hookups. The unit
should be placed where adequate space is available for air circulation and an
AC power source is available.
Do not enclose the unit in a small room or closet without proper ventilation. In
small rooms or restricted areas, the heat given off by the unit may increase
the ambient temperature to an unacceptable level for sufficient cooling of the
resistors.