Bird Technologies 8000 Series - Manual (Page 21)

Reassembly
RF Connector
To install a new connector, reverse the procedures in para-
graph RF Connector, Disassembly. Be sure that the project-
ing center pin on the connector is carefully engaged and
properly seated with the mating socket of the load resistor
input.
Repairs
WARNING
This product contains a resistor substrate made of
beryllium oxide. This is a potentially toxic ceramic and
may be harmful to your health. Beryllia oxide must be
disposed of in accordance with the legal statutes
dealing with hazardous material.
Do not attempt to repair this unit, but return to BIRD
ELECTRONIC CORPORATION.
Due to the unitized nature of the construction, these loads
are not field repairable other than replacement of the “QC”
connector.
Repairs beyond what is covered in this instruction book will
require return of the equipment to Bird Electronic Corpora-
tion for service. Please consult the factory.
Customer
Service
Any maintenance or service procedure beyond scope of those
provided in this section should be referred to a qualified ser-
vice center. Bird Electronic Corporation maintains complete
repair and calibration facilities at the following addresses:
Service Group
U.S.A. Sales and Manufacturing
Bird Electronic Corporation
30303 Aurora Road
Cleveland (Solon), Ohio 44139-2794
Phone: (440) 248-1200
Fax: (440) 248-5426
Maintenance
13