Bennett Marine SLT Self-Leveling Tabs - Manual (Page 2)

congratulations on your purchase of a Bennett SLt System —
an affordable, simple solution for small boats from 10 to 20 feet
(3 m to 6 m). Now you have the durability of a Bennett trim tab system
with a quick and easy installation. Your new Self-Leveling Tabs (SLT)
will improve your ride and boost your boat’s performance:
Plane at lower speeds Improve your hole shot
Improve fuel efficiency Reduce engine laboring
Reduce pounding Eliminate porpoising and
chine walking
u
u
u
u
u
u
How they work
The SLT reacts instantly to boat speed and water pressure by adding
trim when it’s needed. At slower speeds, when the boat is trying to get
on plane, the actuators hold the trim tabs down, which lifts the stern
and simultaneously puts the boat at planing attitude. On plane, and
as the boat’s speed increases, water pressure pushes the tabs up.
You get a better ride while the SLT does all the work.
Quick and easy installation
As you will see on the following pages, installing a Bennett SLT System
can be done with just a few tools and in less than an hour. You can
also change the position of the actuator on the tab with adjustable
mounting options.
Part # Tab Size Tab Boat Size
SLT6 6" x 8"
(15 cm x 20 cm)
10' - 14'
(3 m x 4.5 m)
SLT10 10" x 10"
(25 cm x 25 cm)
14' - 20'
(4.5 m x 6 m)
You selected your kit using this guideline:
If you have any questions about your kit, please contact Bennett
client service at 954.427.1400 (8 a.m. to 5 p.m. Eastern time) or
email [email protected].
2