Bennett Marine ES2000 Euro-Style Rocker Switch Control - Manual

EUROSTYLE ROCKER SWITCH CONTROL
(Part# ES2000)
INSTALLATION INSTRUCTIONS
1. Before you drill any holes, read the entire instruction
sheet.
2. Unsnap the bezel from the control. Using the bezel
locate the position for the control at the helm. Check
carefully to make sure there are no obstructions behind
the dashboard before drilling any holes.
3. The bezel requires a footprint of 2-13/16" x 2-13/16". Cut
a 2-1/2" hole in the center of the footprint using a hole saw.
4. Pull the wire harness up through the hole and attach
it to the back of the control with the ring terminals
enclosed. Please make sure that the gasket is in place
with the flat side down before attaching wires to the control. There are two screws for each wire. (The wire
can be attached to either screw.) The brass strip is marked with the first letter of that color of the wire. All 12
screws must be in place and snug for proper control function.
5. Mark the four locations for the 7/64" pilot holes and drill. Test fastening with the #8 screws. Open the
holes to 1/8" if necessary.
6. Place the wire harness and switch in the hole with yellow connections at top. Secure the switch plate
assembly with the enclosed #8 screws. Be sure the switch is properly seated and snap bezel onto switch
plate assembly.
Note: Bezel will secure completely when BOW DOWN is at top and switch plate assembly is mounted
with top and bottom in proper position with yellow connections at top.
Blue — Pump pressure (trim tabs down)
Yellow — Pump retract (trim tabs up)
Red — Port valve
Green — Starboard valve
Orange with 20 Amp Fuse — 12 volts positive
The above wiring is recommended. If the operator prefers different action from the control and tabs,
it can be changed as desired.
Bennett Marine, Inc. • 550 Jim Moran Boulevard • Deerfield Beach, Florida 33442 USA
Phone: (954) 427-1400 • Fax: (954) 480-2897 • Email: [email protected] • www.BennettTrimTabs.com
Yellow
Red
Blue
Green
7/64" Pilot