Bendix Commercial Vehicle Systems GEN 5 ABS - Manual (Page 17)

17
Fault Codes
FIGURE 20 - Hand-Held Tester Menus and Set-Up
E ato
n A pp
lic atio
ns
1. System INFO
Part No.
Date
Serial No.
Software No.
System Configuration
– ABS
– ATC
Steer Wheel Size
Rear Wheel Size
Rear-Rear Wheel Size
MIC Parameter
2. Trouble Codes
Actual Trouble Codes
Extended Trouble
Codes
Clear Memory
5. System Setup
Eaton ABS
Press Enter
6. ATC Disable
For Dyno Test 8. Exit
System Config
3. Monitor Data
Wheel Speeds
Cut out Speeds
System Volts
Input Switches 4. Component Test
Valve Routines
TCV
WL
TCL
RET
Interface 7. English/Metric
1. System INFO
2. Trouble codes
3. Monitor Data
4. Component Test
5. System Set-up
6. ATC Disable
7. English/Metric
8. Exit
Release
Button
Bendix
Applications Card
MPC™ Cartridge
MPSI Pro-Link
®
Diagnostic and
Power Cable
To
Diagnostic
Connector
Deutsch HD-10
Connector
Hand-Held Tester
An MPSI ProLink ® hand-held tester with Bendix proprietary
cartridge can be used to read and clear error codes and
obtain a short description of failures. The tester can initiate
test sequences for controller outputs and can also read
system data such as voltage at the ECU, wheels speeds
and cutout speeds. A standard heavy duty truck cartridge
may also be used, but cannot initiate test sequences.
CAUTION: The ProLink hand-held tester can activate
output tests for all output devices. Since these tests can
affect operation of the vehicle braking system, the ECU
incorporates special safety protection. One axle must show
zero speed or the test will be halted.