Bendix Commercial Vehicle Systems TABS-6 ADVANCED MC SD SHEET - Manual (Page 40)

40
ECU Part Number Label
The external part number label is located above the control
port of the module. If this label is not readable for any
reason, the Bendix part number is etched into the module
casting above the control port (See Figure 1). A Bendix
manufacturing date code is to the right of the part number
inscription.
There is an additional label under one of the covers that
shows a pin-out diagram for the 12-pin auxiliary connector.
FIGURE 36 ‑ lAbel inFoRmAtion
Production
Data
Component
ID
Final 8 Digits
Show Initial
Software
Loaded
Bendix Part Number
Knorr-Bremse
YYWWDAAAAYYWWDXXXXXXXX
K987654Vxx
X
03
Mxxx
K123456
Software Revision Level
The number of the initial software loaded on the ECU is
also indicated. The current software revision number can
be read using a diagnostic tool.
Document Revision Level
Please visit Bendix.com to ensure you have the latest
version of this document.
BW2726 © 2013 Bendix Commercial Vehicle Systems LLC, a member of the Knorr-Bremse Group • All Rights Reserved • 6/13
Log-on and Learn from the Best
On-line training that's available when you are — 24/7/365.
Visit www.brake-school.com.