Brother, Brother & Sons Ledonardo2 Ver. 2 - Manual (Page 9)

A
USER MANUAL
8
LEDONARDO 2
WWW.BROTHERS-SONS.DK
7
8
1. Mount the supplied cable strain relief with the supplied
screws and washers, and guide the cable through as illustrated.
1. Feed the cable through the Tower as shown.
9
1. Place the Tower in the old housing by first hooking it on to the
the unmounted guidebar using the two nothes A.
2. Lower the notch on the opposite side into the wirepulley
(see the illustration below)
3. Insert the guidebar that we previously dismounted and apply the
four locking rings again. Remember the orientation of the
guidebar ,(short distance at front, large distance in the back).
NOTE: The cable has been partly removed from the illustration to
prevent it from obscuring the view.