Brother, Brother & Sons Ledonardo2 Ver. 2 - Manual (Page 13)

USER MANUAL
12
LEDONARDO 2
WWW.BROTHERS-SONS.DK
INSTALLATION
Do not operate the product if the ambient temperature exceeds 35° C
Provide a minimum clearance of 0,1m (4 in.) around fans and air vents.
This fixture must be connected to ground.
This fixture is for indoor use only.
Read the “Safety” and “Specifications” chapters first.
Applying power:
Never connect to dimmer power
Make sure the local power voltage is within the range specified.
If so; connect the power cable and turn the power on.
Standalone operation:
Using the navigation buttons and display readout ( refer to the “Software Menu” chapter )
navigate to Manual and set the desired intensity.
( additional operations see “Software Menu” chapter)
DMX operation:
Connect a DMX cable
Navigate to Adress mode (Addr) and set the desired adress, resolution, response, strobe,
curve settings and in Personality (PErS) set the desired Fan, No DMX and Display settings.
(refer to the “Software Menu” and “DMX Protocol” chapters)
Connect to DMX controller.
(refer to the “DMX Protocol” chapter)
Use it.
Remove plastic protection from the LED before applying power !