Brother, Brother & Sons Ledonardo2 Ver. 2 - Manual (Page 10)

Approx. 8 mm / 0,31” loose cable.
A
A
B
C
USER MANUAL
9
LEDONARDO 2
WWW.BROTHERS-SONS.DK
10
11
1. In this step we need to guide the cables from the Controlbox
through the Cable access corner.
First attach grommit A, mounted, on the cable to the slot
shown in the illustration. Next take the open grommit B
from the cable access corner and guide both the cable from
the Controlbox and the Tower fan through.
NOTE: The LED cable has a piece of heatshrink (C) mounted
where the cable tube stops. This needs to be on the LED side
of the grommit.
1. Now gently pull the cable from the Tower fan out to
tighten it.
2. Connect the LED cable and the two fancable ends.
3. Using the two supplied cable ties and the cable tie
fastener (A), tie down the cables to prevent them from
getting in front of the LED.
If possible, leave a small amount of excess cable on the
LED side of the cable tie fastener.
This will make it easier, should you need to replace the LED.
1. Mount the cable access corner with the Torx 10 screw.
When mounting, angle the corner as shown, to fit the notch
on the corner into the cutout in the Controlbox.
12