Brother, Brother & Sons Ledonardo2 Ver. 2 - Manual (Page 8)

1
2
USER MANUAL
7
LEDONARDO 2
WWW.BROTHERS-SONS.DK
4
5
6
1. Remove the cable access corner on the Tower by unscrew-
ing the Torx 10 screw, save the screw as you will need it later.
1. Feed the cables from the Controlbox through
the cable hole in the old lamp housing.
2. Lower the old housing onto the controlbox
1. Remove the two screws holding the cable strain relief.
2. Unscrew the three screws holding the on/off switch box.
3. Remove the on/off box and the cables including all ground
wires.