Bang & Olufsen BeoSound 5 Encore - User Guide - Manual (Page 15)

15
Network settings
You can set up your system to a
network either with a wired or a
wireless connection. For the most
reliable network connection
Bang & Olufsen recommends
making a wired connection.
Bang & Olufsen also recommends
that you use a separate router
and access point – a Network Link
router – to ensure the most
reliable playback of digital music.
For more information about
Bang & Olufsen network setup,
contact your retailer.
For further information about
possible music sources,
see
page 18.
Connect one end of the Ethernet cable
to the Network Link router and the
other end to the Ethernet socket on the
music system. The DHCP feature is
default enabled and the music system
will be configured correctly on the
network. If the DHCP feature has been
disabled, follow the instructions under
‘Connect to a network automatically …’.
If, for some reason, IP address, subnet
mask, gateway and DNS server are not
assigned automatically, follow the
instructions under ‘Connect to a network
manually …’.
Connect to a network automatically …
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS and
press GO.
> Use the pointer to highlight NETWORK
SETTINGS.
> Turn the wheel to select ADVANCED and
press GO.
> Turn the wheel to select DHCP and
press GO.
> Turn the wheel to select ENABLED and
press GO. Your music system will now be
configured correctly on your network.
Connect to a network manually …
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS and
press GO.
> Use the pointer to highlight NETWORK
SETTINGS.
> Turn the wheel to select ADVANCED and
press GO.
> Turn the wheel to select DHCP and press GO.
> Turn the wheel to select DISABLED and
press GO.
> Turn the wheel to select IP address,
subnet mask, gateway and DNS server and
press GO.
> Turn the wheel to select value and press GO.
> Repeat the procedure for each relevant
menu item.
Make a wired connection
INTERNET
EXISTING
ROUTER
NETWORK
LINK
ROUTER
NAS
BEOSOUND 5