Bang & Olufsen BeoSound 5 Encore - User Guide - Manual (Page 10)

10
Update software
You can update software
‘manually’ or set the system to
update automatically, when new
software is available.
Do not disconnect the mains while
software is updated.
You can choose to update software
manually or set the system to update
software automatically.
Update software manually …
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS and
press GO.
> Use the pointer to highlight
MAINTENANCE.
> Turn the wheel to select UPDATE
SOFTWARE and press GO.
> The display shows the Bang & Olufsen
logo and the message: ‘Checking for new
software - Press GO to cancel’ appears.
> When the software update is completed,
the message ‘Download completed’
appears on the display. If no new software
is available, the message ‘No new software
update available’ appears on the display.
> Press the standby button on the music
system to switch it to standby and wait
until it switches itself on again for the
software update to take effect.
NOTE! Updating software manually is a one
time operation that does not affect the
setting ‘AUTOMATIC SOFTWARE UPDATE’.
NOTE! Playback is affected when updating
software manually.
Automatic software update …
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS and
press GO.
> Use the pointer to highlight
MAINTENANCE.
> Turn the wheel to select AUTOMATIC
SOFTWARE UPDATE, then select YES.
The setting is disabled from the factory.
> To enable ‘AUTOMATIC SOFTWARE
UPDATE’, turn the wheel to select
ENABLED and press GO to store.
> Use the pointer to leave the menu.
NOTE! We recommend that you enable the
setting ‘AUTOMATIC SOFTWARE UPDATE’.
If the setting is disabled, the system does not
automatically look for new software updates.
NOTE! Your music system does not have an
internal time source. This means that your
music system automatically will check for
software updates every eighth day on an
individual schedule and not synchronous
with other BeoSound 5 Encore music
systems.