Bang & Olufsen BeoSound 5 Encore - User Guide - Manual (Page 11)

11
The pincode system
You can activate a pincode
system and make a pincode of
your own choice. The pincode
system is deactivated when you
store an empty pincode.
The use of a pincode means that
if your music system has been
disconnected from the mains for
more than approximately 30
minutes, it can only be activated
again by switching it on and
entering your pincode.
If the pincode is not entered, the
music system automatically
switches to standby after
approximately three minutes.
To activate the pincode system …
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS and
press GO.
> Use the pointer to highlight
MAINTENANCE.
> Turn the wheel to select CHANGE
Pincode and press GO.
> Turn the wheel to enter a 4-digit pincode
of your choice, press GO to confirm each
digit. Use the right arrow button to delete
digits, if necessary. If all digits are deleted,
the entry is cancelled.
> Turn the wheel to select STORE and
press GO.
> Re-enter the pincode and press GO to
confirm each digit.
> Turn the wheel to select STORE and
press GO.
To deactivate the pincode system …
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS and
press GO.
> Use the pointer to highlight
MAINTENANCE.
> Turn the wheel to select CHANGE
Pincode and press GO.
> Turn the wheel to enter your current
pincode, press GO to confirm each digit.
Use the right arrow button to delete all
digits and select STORE. This will disable
pincode protection.
> You must now store an ‘empty’ pincode.
To do so, turn the wheel to select STORE
and press GO twice.
Five incorrect entries will cause the music
system to shut down for three hours, during
which operation is not possible.
To change the pincode …
> Use the pointer to highlight MODE.
> Turn the wheel to select SETTINGS and
press GO.
> Use the pointer to highlight
MAINTENANCE.
> Turn the wheel to select CHANGE
Pincode and press GO.
> If the pincode system is activated, you
must enter your current pincode before
you can change the pincode. To do so,
turn the wheel to enter your current
pincode, press GO to confirm each digit.
Use the right arrow button to delete digits,
if necessary.
> Turn the wheel to select STORE and press
GO.
> Now turn the wheel to enter a 4-digit
pincode of your choice, press GO to
confirm each digit. Use the right arrow
button to delete digits, if necessary.
> Turn the wheel to select STORE and press
GO to confirm.
> Re-enter the pincode and press GO to
confirm each digit.
> Turn the wheel to select STORE and
press GO.
Note that it is only possible to change the
pincode ten times within a period of three
hours.
1
2
3
4
ENTER CURRENT PIN CODE 5
REMAINING ATTEMPTS: 5 6
7
8
9
STORE