Bang & Olufsen BeoVision Avant CTV (1995-2005) - User Guide - Manual (Page 28)

> Teletext
28
Making video recordings via Teletext
If you connect a BeoCord V 8000 video
tape recorder to your BeoVision Avant,
you can make Timer recordings directly
via the Teletext page listing TV (or
satellite) programmes.
You can programme several Timer
recordings at the same time. Yet the
actual programming procedure varies,
depending on whether the PDC/VPS*
facility in the video tape recorder is
activated or not, and whether the
programme you wish to record is
broadcast with PDC/VPS* signals.
For further information about Timer
recording, please refer to the video
tape recorder’s own User’s guide…
*Note: For further information about the PDC/VPS
facility in connection with Timer recording via
Teletext, see the following page.
A Teletext page with the Timer recording
facility activated.
A status line on top of the page indicates your
recording
Press to switch to Teletext
Call up the Teletext page listing TV
programmes, then...
Press to program a recording
Press to move the cursor to the
programme you wish to record
Press to accept the start time
Make sure the correct stop time is
highlighted...
Press to accept the stop time
Press GO to store the recording
Press to leave Teletext
A cursor appears highlighting the start time of
the first programme on the page…
Alternatively, press tt or ss to move the cursor
The cursor disappears and a status line appears
over the Teletext page, e.g.
18:55 – 19:40 30.JAN P13 BBCWORLD OK?
If the data are not correct, use ss or tt to move
the cursor and ▲ or ▼ to reveal the correct data…
GO
then
TEXT
RECORD
or
GO
The status line now indicates your programmed
recording, e.g. 18:55 – 19:40
RECORD
The cursor is placed on the stop time of the
programme you just selected for recording
To program more recordings, continue to select
programmes…
GO
then
or
EXIT