Autocue MSP17 Master Series Prompter - Manual (Page 30)

www.qtv.com 26 www.autocue.com
Issue
#
: 081
016
©
2003
-200
8
Au
to
cu
e Grou
p Ltd
Section 7: Troubleshooting and Maintenance
Maintenance
Cleaning the monitor
MSP17
Assembly and Installation
Guide
For further troubleshooting assistance, refer to our Frequently Asked Questions
(FAQ) database on our website: www.autocue.com.
7.2: Maintenance
7.2.1: Cleaning the monitor
C AUTION : Electric Shock Hazard!
Isolate the prompter display unit and any other devices from any power
source before cleaning the display unit surface.
Regular cleaning will help keep your prompter display unit in good condition.
• As recommended by the manufacturers, use tepid water with a
small amount of detergent to clean the glass on the prompter
display unit and then leave it to dry naturally.
• Wipe the equipment surface down with a moist cloth; do not
allow liquid to enter the equipment.
• Clean the prompter display unit screen with a lint-free, soft cloth.
Do not use (glass) cleaning agents or paper tissues for cleaning.
In addition, do not clean the glass with abrasive cleaners or
dusters, these will scratch the glass coating.
• Wait until all cleaned parts are completely dry before
reconnecting the prompter display unit to the power source.
Select the H-Total and Phase functions from
the Position menu and change the settings to
achieve a sharp and stable image (these
settings may have to be repeated when you
have selected another graphics mode).
The image is not sized properly or
not centered if the horizontal and vertical image position in
the OSD menu is set correctly
If the selected graphics mode is appropriate
if the display unit supports the graphics mode
of the graphics board
OSD error message: "Signal
overrange” if the selected graphics mode is correct.
if the display unit supports the graphics mode
of the graphics board
Problem Check...