Run menu – Yamato Scientific WG221S Water Purifiers User Manual
Page 34
-32-
Run Menu
Collection of The Fixed Volume of Distilled Water(WG221S)
1. Push the switch to change the collection method and put out the CON. lamp.
Among the operation panel indicators;
●The CON. lamp, the collection method indicator, goes
out.
●The indicator (2) shows the initial value of
.
At the same time, ( ), a unit of water collection, is lit.
2. Push
▲
▲
▲
▲ or ▼
▼
▼
▼ key to set the volume to take.
Among the operation panel indicators;
●The indicator (2) changes the value according to each
your key operation.
(You can set up to 99.9 .)
3. Push the DISTILLED WATER switch.
Distilled water comes out from the outlet.
Among the operation panel indicators;
●The lamp indicating collection of distilled water is lit.
●The indicator (2) starts decreasing the displayed value.
(If the yellow “no water” lamp, one of indicators to show the
level of distilled water stored, is lit during water collection,
the unit automatically stops collection and the lamp
indicating collection of distilled water goes out. In addition,
the indicator (2) returns to the set value.)
4. When the indicator (2) decreases the displayed value down to
and the
remaining water flow of 0.1 is completed;
Among the operation panel indicators;
●The lamp indicating collection of distilled water goes out.
●The indicator (2) returns to the set value.
(The actual amount of collected water may increase or
decrease between maximum
±10％)