Yamato Scientific RE400 Evaporators, Rotary - Manual (Page 8)

6
How to Assemble
3. Insert the rotary joint into the motor.
Push the rotary joint from the right side into the motor sleeve while turning the (blue) flask remover
downward, and fix firmly the rotary joint holder. Keep more than 5mm between the flask remover
and the rotary joint holder. Fasten so tightly that the rotary joint wouldn’t slip even if you pull with full
strength by your single hand. If you fasten loose, the rotary joint might come off during operation, or
be sucked in during vacuumization.
＊ ＊ ＊ ＊ When you remove the rotary joint, don’t take off but loosen the rotary joint holder. If you
remove the holder, the inside parts would come off.
● If rubber parts come off in setting/removing the rotary joint, and you don’t know how to
assemble...
See the following picture to re-assemble when the internal parts come off in setting or removing the
rotary joint.
Keep at least 5mm
Flask Remover
Rotary Joint Holder