How to assemble – Yamato Scientific RE400 Evaporators, Rotary User Manual
Page 10
8
How to Assemble
6. Fit the cooling tube holder shaft (glass type B and C only)
Fit the cooling tube holder shaft firmly into the screw hole on the back of motor. Put the attached
hexagon wrench through the hole on the end, and fasten tight.
7. Fit the cooling tube holder and joint the cooling tube with the connecting
pipe.
Joint the cooling tube to the connecting pipe, and hold by cooling tube clamp. Then, pass the cooling
tube holder from top of the cooling tube, while fitting the other side hole to the holder shaft. Level and
fix the positions by attached butterfly nut. (In case of C type, pass the cooling tube holder from
bottom over the cooling tube and joint it to the connecting pipe.)
＊
＊
＊
＊Wipe the flanges well before you joint the cooling tube to connecting pipe.
Put the suction cock for B type or the cooling tube lid for C type.
Cooling Tube Clamp
Holder
Suction Cock
Lid
- BB300 Low Constant Temperature Water Bath (64 pages)
- BBL100 Low Constant Temperature Water Bath (61 pages)
- BH200 Thermo-Elite (37 pages)
- BH400 Thermo-Elite (42 pages)
- BM100 Water Baths (16 pages)
- BM110 Water Baths (16 pages)
- BM400 Water Baths/Oil Baths (22 pages)
- BM410 Water Baths (21 pages)
- BU200 Low Constant Temperature Water Bath (18 pages)
- CLH301 Cool Line (65 pages)
- CLS301 Cool Line (55 pages)
- DC400 Freeze Dryers (33 pages)
- DG400 Drying Ovens for Laboratory Tools (41 pages)
- DKN 302 Constant Temperature Drying Oven (50 pages)
- DN410H Constant Temperature Ovens (88 pages)
- DN410I Inert Oven (88 pages)
- DNF 400 Constant Temperature Ovens (76 pages)
- DVS402 Constant Temperature Drying Oven (47 pages)
- DX302 Constant Temperature Drying Oven (40 pages)
- DX302 Constant Temperature Drying Oven (9 pages)
- HC200 Cool Block (58 pages)
- HF100 Heating Block (29 pages)
- IJ100 Low Temperature Incubator (27 pages)
- IJ201 Low Temperature Incubator (50 pages)
- K400 Shaking incubator (36 pages)
- IN603 Low Temperature Incubators (68 pages)
- IN603W Low Temperature Incubators (67 pages)
- IQ820 Low Temperature Incubators (46 pages)
- IQ821 Low Temperature Incubators (47 pages)
- LT400A Laboratory Stirrer (21 pages)
- RE200 Evaporators, Rotary (29 pages)
- RE210 Evaporators, Rotary (28 pages)
- RE440 Evaporators, Rotary (25 pages)
- RE550 Evaporators, Rotary (22 pages)
- RT200 Solvent recovery unit (15 pages)
- SN 200 Autoclave, Sterilizers (66 pages)
- Vacuum controller Vacuum controller (34 pages)
- WG201 Water Purifiers (40 pages)
- WG221 Water Purifiers (51 pages)
- WR600A AutoPure (28 pages)
- WS200 Water Purifiers (32 pages)
- External output controller type Ⅳ CR (3 pages)
- Hitech controller type Ⅳ (34 pages)