Brother MFC-7225N - Manual (Page 44)

Troubleshooting
8 - 4
8
3
Verify that the print/scan server is on your network as follows:
For Windows ®
(1) Try pinging the print/scan server from the host operating system command prompt with the
command:
ping ipaddress
Where ipaddress is the print/scan server IP address (note that in some instances it can take up to
two minutes for the print/scan server to load its IP address after setting the IP address).
(2) If a successful response is received, then proceed to Windows ® 98/98SE/Me and Windows NT ® 4.0
Peer-to-Peer print (LPR) troubleshooting, and Windows ® 2000/XP IPP troubleshooting. Otherwise,
proceed to Step 4.
For Macintosh ®
For Mac OS ® 9.1 to 9.2
(1) From the Apple menu, open the Chooser.
(2) Click the Brother Laser (IP) icon, and make sure that your print/scan server name appears in the
right frame. If it is visible, then the connection is good. Otherwise, go to Step 4.
For Mac OS ® X 10.2.4 or greater
(1) From the Go menu, select Applications.
(2) Open the Utilities folder.
(3) Double-click the Printer Setup Utility icon.
(4) Click Add.
(5) Make the following selection. Make sure that your print/scan server appears. If it is visible, then the
connection is good.